Panel Type |
0.74" diagonal (16:9 aspect ratio) |
Lamp |
250 W UHM lamp |
Brightness |
3,500 lumens |
Resolution Native/maximum |
1,280 x 800 pixels (Input signals that exceed this resolution will be converted to 1,280 x 800 pixels. |
Screen Sizes |
33-300 inches, 16:10 aspect ratio |
Display method |
Transparent LCD panel (x 3, R/G/B) |
Pixels |
1,024,000 (1,280 800) 3, total of 3,072,000 pixels |
Lens |
Manual (2 zoom), manual focus F 1.7-2.6, f 24.0-47.2 mm |
Color reproducibility |
Full color (16,777,216 colors) |
Center-to-corner uniformity*3 |
80 (Percent) |
RGB |
G: 0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms; B, R: 0.7 Vp-p, 75 ohms; HD/VD, SYNC: high impedance, TTL (positive/negative) NOTE: SYNC/HD and VD terminals do not accept tri-level sync signals. |
Video/S-Video |
fH: 15.75 kHz, fV: 60 Hz [NTSC/NTSC4.43/PAL-M/PAL60] |
Optical axis shift |
Vertical: 51% from center of screen (manual), |
Keystone correction range |
Vertical: 30 |
Installation |
Front/rear, ceiling/desk (menu selection) |
Built-in speaker |
4 cm (1-9/16 inches) (round) 1 |
HDMI In |
HDMI 19-pin 1, Deep Color, HDCP compatible 480p (525p), 576p (625p), 720 (750)/60p, 720 (750)/50p, 1080 (1125)/60i, 1080 (1125)/50i, 1080 (1125)/24p, 1080 (1125)/60p, 1080 (1125)/50p |
HDMI IN continued |
VGA (640 480)-WSXGA+ (1,680 1,050), compatible with noninterlaced signals only, dot clock: 25.2 MHz-146.25 MHz |
Video In |
RCA pin 1, 1.0 Vp-p, 75 ohms |
S-Video In |
Mini DIN 4-pin x 1, Y: 1.0 Vp-p, C: 0.286 V [p-p], 75 ohms |
Serial In |
D-sub 9-pin (female) x 1 (for external control, RS-232C compliant) |
LAN |
RJ-45 for network connection, 10Base-T/100Base-TX, compliant with PJLink TM |
Cabinet materials |
Molded plastic (PC + ABS) |
Throw Ratio |
1.34-2.68:1 |
Pixel configuration |
Stripe |
HDMI/DVI/D |
fH: 27.0 kHz-68.7 kHz, fV: 24 .0 Hz-85.0 Hz,dot clock: 25.2 MHz-148.5 MHz |
Wireless Module |
Connector for optional wireless module ET-WM200U/WM200E 1 |
DVI-I (analog)/RGB |
fH: 15 .6 kHz-91.1 kHz, fV: 24 .0 Hz-85.1 Hz, dot clock: 162 MHz or lower |
DVI-I IN |
DVI-I 29-pin 1 |
Digital |
DVI 1.0 compliant, compatible with HDCP, compatible with single link only 480p (525p), 576p (625p), 720 (750)/60p, 720 (750)/50p, 1080 (1125)/60i, 1080 (1125)/50i, 1080 (1125)/24p, 1080 (1125)/60p, 1080 (1125)/50p |
Digital continued |
VGA (640 480) -WSXGA+ (1,680 1,050), compatible with noninterlaced signals only, dot clock: 25.2 MHz-146.25 MHz |
Computer (RGB) IN |
D-sub HD 15-pin (female) 1 |
Operation noise |
33 dB (lamp mode: NORMAL), 29 dB (lamp mode: ECO) |
Remote Control Unit Power Supply |
3 V DC (R6/LR6/AA type battery 2) |
Remote Control Unit Operation Range |
Approximately 15 m (49 ft 3 in) when operated from directly in front of the signal receptor |
Wireless Manager ME 5.5 system requirements |
OS: Microsoft |
Wireless LAN |
The optional ET-WM200 is required. IEEE 802.11b/g/n compatible (built-in wireless LAN system or external IEEE 802.11b/g/n LAN card must be installed and running normally.) |
Wireless LAN continued |
Wireless connection may not be possible with some IEEE 802.11b/g/n wireless LAN systems. Macintosh computers must have a built-in wireless LAN adapter. |
Wired LAN connector |
RJ-45 |